Search Results

Problem:  When moving the MPG Pendant really fast and it continues in the same direction or the same speed. Resolution: Inches: You will need to change the 0.01 to 0.05 Metric: You will need to change the 0.1 to 0.5 Keywords: 16025

There are two parameters that affect backlash compensation behavior, the amount and the rate. The backlash amount is a measurable quantity. The rate governs how quickly all the backlash is applied. This value is probably application specific based on the inert...

This installation of a MachMotion control upgrade is the same process no matter what machine type, make or model. Please use the following manual as your guide to locate and mark the old wiring, remove the original system and install the new MachMotion compl...

This document is not for setting up the multiple grinder heads. This document is a guide for setting up a main spindle and subspindle using the 2000 series VFD parameters. It assumes that the VFDs are already properly programmed and communicating on different...

This manual provides an overview the features of the 2050 control. 1. Overview The 2000 series control is an iIndustrial PC control with an integrated 21.5" touch screen and membrane operator panel. 2. Connections 1. Machine interface These are th...

Creating a Tool Setter Open the Calibrate Tool Setters window. Found on the Tools tab. Creating a Manual Tool Setter To create a new manual tool setter, press 'Add New'. All tool setters must have a unique n...

Chapter 1: Introduction G-Code is a special programming language that is interpreted by Computer Numerical Control (CNC) machines to create motion and other tasks. It is a language that can be quite complex at times and can vary from machine to machine. The...

Parameters Parameters are where many of the features and machine functions are setup.  There are many common parameters that are the same across all machine types, but each machine type can have additional parameters for machine specific settings. Viewing an...

Router Dual Table Dual Table is a feature that can used on machines with an overhead axis that normally holds the spindle and Z axis.  The machines have the capability to run a program on ether table or link both tables together to make one large table. There...

Chapter 1: Introduction G-Code is a special programming language that is interpreted by Computer Numerical Control (CNC) machines to create motion and other tasks. It is a language that can be quite complex at times and can vary from machine to machine. The...

Adjusting Pendant Acceleration You can adjust the pendant acceleration by going to the Settings Tab and selecting Machine Calibration (2000 series: select the Service Tab at the bottom of the main screen, and click the Interface Config button near the top of ...

Adjusting Pendant Acceleration To access the pendant acceleration settings: Disable MachPro Pull down Configure -> Control Select the Settings tab Collapse the settings tree  Expand the Jogging section. In the MPG section, you can enter values ...

Open the Calibrate Tool Setters window. Found on the Tools tab. Creating a Manual Tool Setter Mapping the input to a software signal Pull down Configure -> Control and select the Input Signals tab. Some signals are pre-configured when MachPro is instal...

MachPro 26 CNC Software Roadmap This manual provides an overview the features of the Orion 3000 CNC Control. 1. Overview The Orion 3000 control is an industrial control with an integrated 21.5" touch screen and operator panel. 2. Connections The Orion...