Search Results

X15-72-02 Tabletop Mount    

Remove these 8 screws. Remove these 6 screws. With the bottom back cover already removed, remove the wingnut and ground wire. Remove aux. USB plug (should be in in slot 2). Remove the pendant cable from control enclosure (unscrew the little nut...

How to connect the wires to the connector that comes with the Vertical Touchscreen Monitor (100201).

You will need to be in the Manufacturing Order you are working on. Go into Transfers (top of page) and go into the "PC". You will need to "Check Availability" to reserve the parts to the "MO". Physically go pick the parts and then come back and "Validate" t...

The following information was taken from Nidec's "Installation Instructions and Safety Precautions" page. For Inline and Right angle planetary products - VR/EV series. It is the consensus that this information would be used for all brands unless otherwise note...

How to assemble the Dual Monitor Kit on an HMI! I have found this is the best order to assemble this kit. Install the back mount. Install the conduit grip (this can be done by hand, hold the inside nut with fingers and tighten with channel locks, if y...

How to assemble the Tool Tray Kit on an HMI. Two people are almost required to do this. Install the USB Hub on the large center tool tray (the right photo shows the USB Hub to be installed on the left photo, red circle).    One person hold the center ...

How to mount the 2K series with a swivel to a stand or bottom arm mount.  It would be mighty handy to have an extra set of hands for this one. It can be done with one person if need be though. The order of the "swivel sandwich" is very important. From top d...

INtime is the RTOS (Real-Time Operating System) in which the actual motion controller runs. It must be installed and configured before our RapidPath solution will work. Installing INtime Run the installer. Perform a "Complete" installation (the default). Th...