Search Results

The laser alignment is set by tool offsets. This is in the tool table and down at the bottom.  You can pierce a small hole with the torch and zero out the DROs at that point.  Then turn on the laser and jog until the laser aligns to the hole.  Then set those o...

To adjust the amount torque offset you will need to do the following steps. Move torch over material as a torch touch off will be done. User left click on "Enable" User left click on "Settings" User left click on "Neuron Settings" User left click ...

Plate Alignment Plate alignment provides a simple way to accurately rotate your work offsets to match the work piece on your table. Often large work pieces are not perfectly square on the table, and this tool solves that problem.  First steps Remove G69 (...

Introduction Overview GCode Header Parameters let Mach read setup values from the top of a loaded G-code file and automatically push those values into OEM registers or machine-specific handlers. This is intended for program metadata such as cut heights, pier...

This is a set of reference screens for use with the MachPro Plasma Setup Manual The settings below are in alphabetical order - not the order they are used while running the plasma machine. Pull down Configure -> Control -> and click the Settings tab. You m...

MachPro 26 CNC Software Roadmap Configure Motion Controller Please refer to your motion controller's documentation to: Establish the network connection to the MachPro computer Connect and configure drives Connect and configure I/O Calibrate the axe...

Introduction Overview This manual gives an overview for the basic operation of the MachPro Plasma control. The screens are shown below, followed by a brief summary of the features of each screen. The numbers shown in the screenshot refers to a brief descri...