Skip to main content

Update Mach4 without internet to control

To update Mach4 software without internet to the control you can do so by completing the following procedures:

Items you will need:

  • USB Flash Drive
  • Computer with internet connectivity

UPDATING MACH SOFTWARE:

Before you begin, ensure the Mach4 software/program is closed.

1. Download and Run the Mach4 Installer http://machmotion.com/download/Mach4/
2. On the drop down select the most recent Build Number
3. Save it to a USB Flash Drive
4. Move the file from the USB Drive to the MachMotion Programs and Drivers folder
5. Go to the C: Drive and find the Mach4 folder.

a. Right click and click copy
b. Go to the MachMotion Programs and Drivers folder and Paste it into this folder


6. While in the MachMotion Programs and Drivers folder double click on the MachMotion
Installer for the Build Number that you downloaded

a. Follow through the steps make sure to select the correct profile type and "Hicon"

 

7. On the desktop, open the "MachMotion Programs and Drivers" icon/folder.

8. Run the VSI Device Manager program

9. Click on the "Scan Network" button

10. Click on the IP address that shows up in the list (for example: 192.168.208.35)

11. Click the "Switch To Loader" Button

12. User left click on "OK (push button)" in "VSIDeviceManager.exe"
R0171
Step 7: User left click on "OK (push button)" in "VSIDeviceManager.exe"
Step 8: User left click on "Load File (push button)" in "VSI Device Manager (v5.22)"
R0171
Step 9: User left click on "HiCON Firmware"
Step 10: User left click on "Open (push button)" in "Select file"
R0171
Step 11: User left click on "Program Flash (push button)" in "VSI Device Manager (v5.22)"
Step 12: User left click on "OK (push button)" in "VSIDeviceManager.exe"
R0171
Step 13: User left click on "OK (push button)" in "VSIDeviceManager.exe"
Step 14: User left click on "OK (push button)" in "VSIDeviceManager.exe"
R0171
Step 15: User left click on "OK (push button)" in "VSIDeviceManager.exe"
Step 16: User left click on "Scan Network (push button)" in "VSI Device Manager (v5.22)"
R0171
Step 17: User left click on "Activation (page tab)" in "VSI Device Manager (v5.22)"
Step 18: User left click on "192.168.208.35 (list item)" in "VSI Device Manager (v5.22)"
R0171

 

 


8. Once finished open up the Mach4 software
9. Click on Help=>About and see if it is licensed

a. If not please Call Technical Support

10. Go to Config=>Plugins=>MachMotion

a. Click on Load Registers
- Locate C:/Mach4/Profiles/Mill and select the Registers file
b. Click on Load Parameters
- Locate C:/Mach4/Profiles/Mill and select the Parameters file

11. Go to Config=>Mach

a. Make sure the Advanced GUI Controls is unchecked

12. Please close Mach4 and then open it back up and test

 

15530

Back to top