Mach4 Plasma Torque Offset
To adjust the amount torque offset you will need to do the following steps.
Move torch over material as a torch touch off will be done.
User left click on "Enable"
User left click on "Settings"
User left click on "Neuron Settings"
User left click on "Start Setup " in "Diagnostics" Tab
User left click on "Yes (push button)" in "Neuron Controller"
The torch will then move down to the plate and then come off.
Measure how far torch is from the plate.
Use the Tip Volts knob on the operating panel to adjust the offsettorch tountil matchit is physically .200" off the measuredplate. distanceThe ofoffset torchamount fromwill plate. automatically be applied in the offset value now.
User left click on "Start Setup (check box)" in "Neuron Torch Height Control :: Settings"
The torch will than move rapidly up to the home postion
User left click on "Yes" in "Neuron Controller"
User left click on "OK (push button)" in "Neuron Controller"
