Mach4 Plasma Torque Offset

To adjust the amount torque offset you will need to do the following steps.

Move torch over material as a torch touch off will be done.

User left click on "Enable"

 

User left click on "Settings"

User left click on "Neuron Settings"

User left click on "Start Setup " in "Diagnostics" Tab

User left click on "Yes (push button)" in "Neuron Controller"

The torch will then move down to the plate and then come off.

Measure how far torch is from the plate.

Use the Tip Volts knob on the operating panel to adjust the offset to match the measured distance of torch from plate. 

User left click on "Start Setup (check box)" in "Neuron Torch Height Control :: Settings"

 

The torch will than move rapidly up to the home postion

 

 User left click on "Yes" in "Neuron Controller" 

 User left click on "OK (push button)" in "Neuron Controller"