Dual VFD Accelerations

If you want to run most of your tools at an aggressive acceleration but still use a long acceleration on your large tooling this is one way to do it.

First run a wire from an output to one of the VFD inputs. then build a PMC (attached)

This one is turning on the output when out current tool number is between 200 and 300. 

So 1-199 will use "Time 1" and 200-300 will use "Time 2"

the VFD will default to "Time 1", and an active low output will switch it to "Time 2"

I used S1 on the VFD