| Sub |
Description |
Description
| 1 |
| Lock Pre Run Routine
|
| 2 |
| Hinge Pre Run Routine
|
| 3 |
| Lock Post Run Routine
|
| 4 |
| Hinge Post Run Routine
|
| 9 |
| Loader: Check To See If Door Is Loaded on Conveyor
|
| 10 |
| Loader: Load Door From Load Stack to Conveyor
|
| 11 |
| Loader: UnLoad From Conveyor To Stack
|
| 12 |
| Loader: Settings
|
| 13 |
| Loader: Positioning Door On Conveyor
|
| 15 |
| UnLoader: Routine
|
| 16 |
| UnLoader: Move From Unloader Stack Back to Conveyor #4
|
| 9001 |
| Set Mach Parameters
|
| 9002 |
| End of Door Probe
|
| 9003 |
| Set G54 in Hinge Instance
|
| 9004 |
| Raise Pedrail conveyor and Send Door into Machine, Clamp Door
|
| 9005 |
| Unclamp Door, Send Door Back to Loader
|
| 9006 |
| Lock: Lift Entry and Exit Vertical Clamps
|
| 9007 |
| Probe Door Thickness
|
| 9008 |
| Probe Door Width (If you want to adjust your X0 on the side of the door change #100 in this subroutine)
|
| 9009 |
| Send Door to UnLoader
|
| 9010 |
| Raise Pedrail conveyor and Send Door into Machine
|
| 9011 |
| Center Door On Conveyor 1
|
| 9012 |
| Move to door width |
| 9013 |
| Manual: Send door into Machine
|
| 9014 |
| Top Clamps On |
| 9015 |
| Top Clamps Off |
| 9016 |
| Hinge Bevel Off
|
| 9017 |
| Hinge Bevel On
|
| 9018 |
| Hinge: Lock Worktable
|
| 9019 |
| Hinge: Unlock Worktable |
| 9020 |
| Move Work Table to Nearest Tooth |
| 9021 |
| Move Door to Center of Conveyor
|
| 9022 |
| Probe End of Door
|
| 9024 |
| Hinge: Side Clamp On
|
| 9025 |
| Hinge: Side Clamp Off |
| 9026 |
| Unclamp Door
|
| 9035 |
| Extend Width Measure
|
| 9036 |
| Retract Width Measure
|
| 9050 |
| Hinge: Calculate Tool Offset |
| 9054 |
| Lock: Calculate Tool Offset |
| 9055 |
| Lock Bevel Touch Off |
