| Sub |
Description |
| 1 |
Lock Pre Run Routine |
| 2 |
Hinge Pre Run Routine |
| 3 |
Lock Post Run Routine |
| 4 |
Hinge Post Run Routine |
| 9 |
Loader: Check To See If Door Is Loaded on Conveyor |
| 10 |
Loader: Load Door From Load Stack to Conveyor |
| 11 |
Loader: UnLoad From Conveyor To Stack |
| 12 |
Loader: Settings |
| 13 |
Loader: Positioning Door On Conveyor |
| 15 |
UnLoader: Routine |
| 16 |
UnLoader: Move From Unloader Stack Back to Conveyor #4 |
| 9001 |
Set Mach Parameters |
| 9002 |
End of Door Probe |
| 9003 |
Set G54 in Hinge Instance |
| 9004 |
Raise Pedrail conveyor and Send Door into Machine, Clamp Door |
| 9005 |
Unclamp Door, Send Door Back to Loader |
| 9006 |
Lock: Lift Entry and Exit Vertical Clamps |
| 9007 |
Probe Door Thickness |
| 9008 |
Probe Door Width (If you want to adjust your X0 on the side of the door change #100 in this subroutine) |
| 9009 |
Send Door to UnLoader |
| 9010 |
Raise Pedrail conveyor and Send Door into Machine |
| 9011 |
Center Door On Conveyor 1 |
| 9012 |
Move to door width |
| 9013 |
Manual: Send door into Machine |
| 9014 |
Top Clamps On |
| 9015 |
Top Clamps Off |
| 9016 |
Hinge Bevel Off |
| 9017 |
Hinge Bevel On |
| 9018 |
Hinge: Lock Worktable |
| 9019 |
Hinge: Unlock Worktable |
| 9020 |
Move Work Table to Nearest Tooth |
| 9021 |
Move Door to Center of Conveyor |
| 9022 |
Probe End of Door |
| 9024 |
Hinge: Side Clamp On |
| 9025 |
Hinge: Side Clamp Off |
| 9026 |
Unclamp Door |
| 9035 |
Extend Width Measure |
| 9036 |
Retract Width Measure |
| 9050 |
Hinge: Calculate Tool Offset |
| 9054 |
Lock: Calculate Tool Offset |
| 9055 |
Lock Bevel Touch Off |
