MachPro Mill and Router Setup Manual

{{@2007#bkmrk--1}}

MachPro 26 CNC Software Roadmap

Introduction

Please refer to the Motion Controllers documentation to:

• Establish the connection between the motion controller and the MachPro computer
• Connect and configure drives

Work with your motion controller documentation and the appropriate MachPro Motion Controller Integration Documentation for the following steps:

1. MachPro Startup
2. Axis setup
3. Axis calibration
4. Mapping input signals (see default mapped inputs and outputs table below)
5. Homing setup
   • Homing slave axis - if present
   • Troubleshooting
6. Soft Limits setup
7. Mapping output signals
8. Using outputs
9. Spindle setup

Some of these configuration steps need integration with the MachPro software. The M31 Motion Control Setup Manual includes the information you need for the M31. Compatible motion controllers should complete the  MachPro Compatible Motion Controller Configuration Settings

Languages

{{@2205}}

Spindle Calibration

This is primarily for mills where the speeds and feeds are precise, and directly affect the finish and accuracy of the final part. Spindle speeds on routers are usually not as precise. 

Spindle Settings

{{@2047}}

Global Monitoring System (GMS)

{{@2002}}

Lube System Setup

{{@2046}}

Modifying GoTo Positions

{{@2045}}

Tool Setters and Offsets

{{@1995}}

Probing Wizard

{{@2206}}

Blum Probing Modules

{{@2203}}

Modifying GoTo Positions

{{@2045}}

Tool Changers

{{@1999}}

{{@1998}}

Drill Bank Setup and Operation

Other Machine Settings

Pull down Configure -> Control and select the Settings Tab and scroll down to the Machine section

Work Light Output

Pull down Configure -> Control and select the Settings Tab and scroll down to the Work Light section

Additional Information

For information about MachPro Software Operation please see the MachPro Mill/Router Operating Manual

{{@2016}}