MachPro Mill and Router Setup Manual

{{@2007#bkmrk--1}}

Configure Software

Please refer to your motion controller's documentation to:

• Establish the network connection to the MachPro computer
• Connect and configure I/O 
• Connect and configure drives
• Connect and configure the spindle
• Connect and configure I/O 
• Calibrate the axes
• Establish machine zero
• Configure soft limits
• Calibrate the Spindle

Spindle Calibration

This is primarily for mills where the speeds and feeds are precise, and directly affect the finish and accuracy of the final part. Spindle speeds on routers are usually not as precise. 

Spindle Settings

{{@2047}}

Global Monitoring System (GMS)

{{@2002}}

Lube System Setup

{{@2046}}

Tool Setters and Offsets

{{@1995}}

Probing Wizard

{{@2015}}

Modifying GoTo Positions

{{@2045}}

Tool Changers

{{@1999}}

{{@1998}}

Drill Bank Setup and Operation

Other Machine Settings

Pull down Configure -> Control and select the Settings Tab and scroll down to the Machine section

Work Light Output

Pull down Configure -> Control and select the Settings Tab and scroll down to the Work Light section

Additional Information

For information about MachPro Software Operation please see the MachPro Mill/Router Operating Manual

{{@2016}}