Dual Monitor Kit Assembly on the HMI

How to assemble the Dual Monitor Kit on an HMI!

I have found this is the best order to assemble this kit. Follow the photos.

Install the back mount.

Install the conduit grip (this can be done by hand, hold the inside nut with fingers and give a 1/4 to 1/2 turn on the outside conduit grip with channel locks)

The Monitor power cable (it will be covered by the mount when the monitor is installed on the mount).

Monitor to Mount.

Plug Cable into Monitor.

Put on Split Loom.

It is easier to remove the tightening nut and rubber seal. Slide those on the cables and split loom (in the correct orientation) and then run the cables through the conduit grip. One can manage to get the cables through the grip without the removal though.

Plug the cables into the correct place and be sure to give slack so the cable are not strained at the terminal. 

Slide the split loom in and tighten the conduit grip (the rubber seal doesn't have to have its guts spilling out, tight enough that the loom doesn't pull out is perfect). You can even put a zip tie on the Monitor side of the split loom for added security. 

Done!!!