Search Results

MachPro 26 CNC Software Roadmap Introduction Some of the following configuration steps are integrated with the MachPro software. The M31 Motion Control Setup Manual includes the information you need for the M31. Compatible motion controllers should compl...

If you are setting up the GoTo position for a tool setter, jog the tool to the correct position over the tool setter.  Pull down Configure -> Control -> GoTo Positions tab Position Setup Instructions Use the Add or Remove buttons at the bottom to ma...

If your system has an oiler edit the lube settings. Pull down Configure -> Control, and select the Settings Tab. Scroll down to the Lube System settings. Enable the lube system, and adjust the settings. In the default settings, the oiler will only run while th...

These are the  settings for the most commonly used Spindle features. Pull down Configure -> Control -> Settings tab  Click the button to flatten the full settings tree, then expand the Spindle section Gear shifter Before configuring the gear shifter...

Modify GoTo Positions

These instructions apply to all VFDs where the spindle is controlled through the MachPro Control Spindle tab Why calibrate your spindle? Does your CNC control need it? Mills and Lathes need to be calibrated while routers typically do not. The spindle speed n...

MachPro Package Installation Start with the MachPro Package Installation software, which will also prepare your computer for the motion control setup.  Motion Controllers The compatible document in the right column will guide you to: calibrate axes, map i...

Example photo of a Drill Bank: (KOMO 20 Position Drill Bank. 14 Vertical, 6 Horizontal.) Drill Bank Example Drawings (From above looking down): In the above example; numbers 301-314 are Vertical Drills and numbers 315-317 are Horizontal Drill Units (2 ...

Documentation is attached. Look to the upper left for your attachments. 

The tool can’t stop instantaneously on contact when probing. The tool will travel some distance into the material. How far it will travel after actual contact is determined by the machinesconfiguration and the probing feedrate. The controller will react to con...

Documentation is attached. Look to the upper left for your attachments. 

Documentation is attached. Look to the upper left for your attachments. 

Documentation is attached. Look to the upper left for your attachments. 

Documentation is attached. Look to the upper left for your attachments. 

Documentation is attached. Look to the upper left for your attachments. 

Documentation is attached. Look to the upper left for your attachments. 

Documentation is attached. Look to the upper left for your attachments. 

Documentation is attached. Look to the upper left for your attachments. 

Documentation is attached. Look to the upper left for your attachments.