Data Collector

Overview

The data collector plugin allows you to track the state of a signal between multiple runs of Mach4. For example, you can fault out after 1000 hours of the spindle running. 

To reset from a fault, press the user button on the screen. That will make it start counting from zero again. 

 

 

Follow these steps to set it up:

1. Update Mach4 to 8640 or greater
2. Copy the files from "SVN Codebase"\DataTracking\DataCollector\ to the control
   1. Copy these to C:\Mach4\Plugins
      1. DataCollector.sig
      2. DataCollector.m4pw

3. Enable the plugin “DataCollector – MachMotion"

4. Restart Mach4

5. Go to Configure -> Plugins -> Data Collector

1. Select Add
2. Setup the configuration as follows

 

6. Press Save

7. Copy the files from "SVN Codebase"\DataTracking\ to the control

1. Copy this to “C:\Mach4\Profiles\Router\Macros\Scripts”
   1. UserGUIModule.mcs
   2. Note: if you do it earlier you will get errors while loading the screen

8. Create a GMS message as follows

9. Set the conditions up as follows

10. Setup Aux 1 button to say "Reset\nGrease\nWarning" and set the output to any unused output as shown below: