Wincore Jamb Router

All directions are referenced from the operator's point of view

Homes positive towards the front of the Router. Works in the negative machine (G53) space.

Part Zero is center of the tool at the back edge of the jamb

Homes negative away from the operator. Works in the positive machine (G53) space.

Part Zero is center of the tool at the edge of the jamb farthest from the operator.

Teach Saw to the End of Board button is on the Dashboard tab under the Service tab

Homes positive (Up). Works in the negative machine (G53) space.

Part Zero is the tool at the top surface of the jamb at the back. So really it is the underside of the clamps.

A (Center Clamp):

Homes negative. Works in the positive machine (G53) space.

B (Right side Clamp):

Homes positive. Works in the negative machine (G53) space.

These 2 clamp axes use the same rack and move parallel to each other. This means they can collide or hit each other limit switches.

1. First Saw Cut

2. First Dado

3. Hinges

4. Strikes

5. Last Saw Cut

6. Last Dado

7. Header Holes