Architectural Grille Configurable Parameters
Standard Parameters
| Sub-Category | Name | Description | Comments |
|---|---|---|---|
| Machine Data | LCM_DataDir | Data Directory | where the CSV data files are stored These are used for calculations. |
| Post | LCM_MaxSpacing | Maximum Spacing between Center of Notches | threshold used in calculations |
| Post | LCM_SafeStartLine | Safe Start Line |
The safe start block(s) used in generated G code files. machine-specific |
| Post | LCM_TrimLength | X length to trim to square leading end of material | |
| Post | LCM_ProbeFeedRate | Feed rate for probe moves | |
| Post | LCM_DrillFeedRate | Feed rate for drill moves | |
| Post | LCM_DrillRPM | RPM for drilling | |
| Post | LCM_PusherFeedRate | Feed rate for pusher moves | |
| Post | LCM_FeedDirection | Direction the machine feeds | |
| Post | LCM_SawCutFeedrate | Feed rate for saw cuts | |
| Post | LCM_SawSpindleSpeed | Spindle Speed for Saw Cuts (RPM) | |
| Post | LCM_DoorPivotMatchesFeedDir | Door pivot type matching feed direction | |
| Wizard | LCM_JobList_ShowWorkspace | Show Workspace in Job List | |
| Wizard | LCM_EnableWorkspaces | Enable Workspaces | |
| Probe | LCM_ProbeOffset | Distance from X0 to the probe trigger position | |
| Drill | LCM_PerformDrillOperations | Perform drill operations | |
| Drill | LCM_DrillOffset | Distance from saw blade center to the center of the drill bit | |
| Drill | LCM_DrillClearanceZ | Z position for the drill to avoid any material | |
| Drill | LCM_DrillDepthClearance | Distance past the material to drill | |
| Saw | LCM_SawClearanceY | Y position for the saw to avoid any material (G53) | |
| Saw | LCM_SawCutoffY | Y Amount Added to Height for a cut-off | |
| Saw | LCM_SawKerfWidth | Saw Kerf Width | |
| Saw | LCM_SawDiameter | Saw Diameter | |
| Saw | LCM_SawXPosition | Saw Position (machine coordinates) | |
| Pusher | LCM_PusherMinimumX | Minimum X position to command the pusher | |
| Pusher | LCM_PusherLoadOffset | Pusher Load Offset From Saw | |
| Pusher | LCM_PusherRetractPosition | Pusher Retract Position (machine coordinates) | |
| Shapes | LCM_ShapesClampsSpace | Distance Between Shapes Clamps (W) | |
| Shapes | LCM_ShapesSawCutWEnd | W Start Position for Shapes Saw Cut | |
| Bundles | LCM_BundlesSawCutWEnd | W End Position for Bundles Saw Cut | |
| Workspace | LCM_EngageTableClampsInJob | Enable the Table Clamps/Supports in a Job | |
| Signals | LCM_WorkspaceShapesOutput | Signal to Enable Shapes Supports | |
| Signals | LCM_ForceTableClampDisengage | Signal to Force Clamp Disengage | |
| Signals | LCM_TriggerAutoEngageOutput | Signal to Trigger an Automatic Clamp Engage | |
| Signals | LCM_TableClampsStateOutput | Signal represeting the Table Clamps State | |
| Options | LCM_HasOutfeedClamps | Machine has outfeed clamps |