Yaskawa V1000 Communication Setup

Change IP and Communication Parameters On V1000

Quick access for the correct parameters:

  • B1-01 : 3
  • B1-02 : 3
  • B1-08 : 1
  • F6-01 : 0
  • F6-03 : 0
  • F6-14 : 1 (Cannot be changed from the front panel.  Use Drive Wizard for this parameter) 
  • F7-03 : 208
  • F7-04 : 090 (If multiple drives are present, see step 10 below.)
  • F7-13 : 00
  • O1-03 : 1 on release later than 16161. Not for A1000 or GA500.



For a A1000 or a GA500 or a GA800, also update the following parameters:

  • H5-11 : 1
  • O1-03 : 3


For a A1000, additional setup the following parameter:

  • O1-11 : 1 


If there is a delayed safety relay, you also need to set up the following:

  • H1-07: 17
  • C1-09: 4 (Or to your deceleration time)




Follow these instructions to change parameters in the drive:

1) Press down arrow until screen reads "PAR." Press Enter.

2. Press down arrow the screen reads "F7-01."

3. Press ">Reset" two times until "01" is flashing.

4. Press the up arrow until the value reads "13." Press Enter.

5. Use the arrow to change the value to "00." Press Enter. The screen will flash "End" and go back to the previous screen.

6. Use the moves in 4 and 5 to change the remaining parameters:

       -Change F7-03 to "208"

       -Change F7-04 to "90"

7. Press ESC until the "F" on the screen is flashing. Then, press the down arrow until the screen reads "b1-01."

8. Use the steps in 3 to 5 to change the remaining parameters:

       -Change B1-01 to "3"

       -Change B1-02 to "3"

       -Change B1-08 to "1"

       -Change F6-01 to "0"

      -Change F6-03 to "0"

       -Change F6-14 to "1"

9. Power cycle control and enclosure to reset VFD.


NOTE: For multiple V1000's, each drive will need it's own IP address. So, set the F7-04 parameter for each drive in ascending order (90, 91, 92.)

NOTE: For the B1-01 and B1-02 parameters, we ship many of our drives with an option card that requires them both be set to "3." But, if these settings trip an alarm, see manual to determine correct parameters.