Teco Drive Power Conversion Kit-GS2

To help convert the incoming power lines for the teco drives from the older style TSTA to the new style GS2, use the conversion kit, part # CCTG-CONV-KIT.

The kit contains 3 pre-wired lever nuts (or similar) and can be used for IO6 and Apollo I type setup (r,s jumpered from R,S). Will work for single phase or 3-phase as well.

Ensure power is off and confirm no voltage is present with a volt-meter before performing the conversion. Failure to do so may result in DEATH, INJURY, or serious PROPERTY DAMAGE.

General Kit Overview:

  • (2) 3-lever nuts
  • (1) 2-lever nut
  • (5) 14 gauge crimp-on ferrules
  • ~2ft 14AWG stranded copper wire
    • Cut to (5) 4" length strips
    • Ferruled on one end
    • 3/8" insulation strip on lever nut end

TSTA Teco Drive Terminals:

GS2 Teco Drive Terminals:

To use these connections, us a small flat blade screwdriver and push down on the orange block to open the terminal port. Insert wire, then release the orange block. Gently but firmly tug on wire to ensure it is securely fastened.