Spindle Turning off Intermittently-Mach3

Description of the problem:

The spindle is turning on/off intermittently 
 
Solution:
If the oiler output (in the MachMotion plugin) is set to output1 or output2 (this is typical, but could be different depending on configuration of spindle tab settings in  ports&pins) is will cause the spingle to turn on/off inexplicably. Any other output should work.
 
q6uoiler.png
 

Revision #5
Created Thu, Jul 27, 2017 1:15 PM by Aaron
Updated Wed, Jul 24, 2019 8:38 PM by Josiah Ymker