Spindle Brake Setup-Mach3

Description of the problem:

I'm trying to set up my spindle brake.
 
Solution:
To enable spindle brake:
1. Go to Config->Config Plugins
2. Click on the CONFIG button on the MachMotion plugin

For MachMotion Plugin V4 and earlier:
3. Press the System Configuration Button
4. Check "Enable Spindle Brake (Output #19)"
5. Select [Save] and close out the windows

For MachMotion Plugin V5 and later:
3. Go to the Special Functions tab
4. Check "Enable Spindle Brake (Output #19)"
5. Select [Save] and close out the windows
 
Spndle-Brake-MachMotion-Plugin.jpg

Note: You will need to configure Output19 in Config->Ports & Pins->Output Signals to the output you are using for the brake.
 
Keywords: 7723

Revision #5
Created Thu, Jul 27, 2017 1:22 PM by Aaron
Updated Wed, Jul 24, 2019 8:41 PM by Josiah Ymker