Macropump Issues-mach3

  • Macropump is not working correctly.
     

    - If the debounce is set too high it can delay inputs used in the macropump.m1s so much that the macropump does not function.

     

     

    Macropump is not working even though it is enabled in Config->General Config.

     
    - When a new macropump file is written into the folder it sometimes stops working. To fix it uncheck the run macropump option in General Config, restart Mach3, re-check it, and restart again and it will work. It is an internal issue with Mach3
     
    Keywords: 7660, mach3
     
 

Revision #4
Created Thu, Jul 27, 2017 1:05 PM by Aaron
Updated Wed, Jul 24, 2019 8:37 PM by Josiah Ymker