1000 Series Mach4 Aux Button Setup

On the 1000 Series control, there are six user auxiliary buttons that can be configured.

 

Mach4-Aux-Buttons.png

To configure the buttons, select the "Settings" tab the lower right of the screen and then press "Screen Configuration."

 

Mach4-Auxiliary-Outputs.png 

Each button can be configured to activate a given output signal from the drop-down menu. The user can change the button text in both on and off states. The button could also be defined as momentary or toggle. The defined output signal must be enabled and mapped to a device in Mach settings.

You can put text on another line. For example if you put Hydraulics On as the text, it may not fit. You can put a \n for a line break. For example, Hydraulics\nOn would put the word On below the word Hydraulics in the button.

 

When finished, press "Save" then "Exit" and restart the software for the changes to take effect.

 

 

Keywords: 10612, auxiliary buttons, auxilary, auxillary, auxilliary


Revision #6
Created Thu, Jul 27, 2017 1:34 PM by Aaron
Updated Thu, Jul 25, 2019 9:32 PM by Josiah Ymker